Ribbon print Printer User Manual download pdf (Page 18)

Note:

1. Dump mode requires 4” wide paper width.

2. Turn off / on the power to resume printer for normal printing.

3. Press FEED button to back to the previous menu.

Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults. The

only one exception is ribbon sensitivity, which will note be restored to default.

Printer initialization is activated by the following procedures.

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED turns green after 5 amber blinks. (Any green will do

during the 5 blinks).

 The LED color will be changed as following:

Amber Æ red (5 blinks) Æ amber (5 blinks) Æ green (5 blinks) Æ green/amber (5

blinks) Æ red/amber (5 blinks) Æ solid green

Printer configuration will be restore to defaults as below after initialization.

Parameter Default setting

Speed 127 mm/sec (5 ips) (203DPI)

76 mm/sec (3 ips) (300DPI)

Density 8

Label Width 4” (101.5 mm)

Label Height 4” (101.5 mm)

Sensor Type Gap sensor

Gap Setting 0.12” (3.0 mm)

Print Direction 0

Reference Point 0,0 (upper left corner)

Offset 0

Tear Mode On

Peel off Mode Off

Cutter Mode Off

Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit

Code Page 850

Country Code 001

Clear Flash Memory No

IP Address DHCP

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

No comments

Ribbon print Printer User Manual Page 18