Ribbon print Printer User Manual download pdf (Page 17)

Self-test

Printer will print the printer configuration after gap/black mark sensor calibration.

Self-test printout can be used to check if there is any dot damage on the heater element,

printer configurations and available memory space.

Print head test pattern

Printer model name & Main board firmware version

Printed mileage

Main board firmware checksum

Serial port setting

Code page

Country code

Print speed

Print darkness

Label size (width, height)

Gap size (vertical gap, offset)

Sensor sensitivity

File management information

 Dump mode

Printer will enter dump mode after printing printer configuration. In the dump mode, all

characters will be printed in 2 columns as following. The left side characters are

received from your system and right side data are the corresponding hexadecimal value

of the characters. It allows users or engineers to verify and debug the program.

ASCII Data

Hex decimal data related to

left column of ASCII data

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

No comments

Ribbon print Printer User Manual Page 17